Installing a Brick Paver Walkway or Engineering Bricks

The use of Bricks or Pavers to create a walkway or patio complements a house in a method that is unrivaled. In addition, installing a Brick or Paver walkway does not always need a pro.

The key to installing a Brick or Paver Walkway is to very first effectively prepare the area where the bricks/pavers are to be installed. The location ought to be dug out at least a foot down, getting rid of all topsoil and clay soil. In addition, string lines need to be strung on each side of the pathway. The string lines indicate the finished height of the pathway.
When the area has actually been dug down, 3/4" gravel stone need to be laid in and tamped down tightly. 2" of sand, or stone dust should be spread out over the gravel. Again the sand/stone dust need to be tamped down. Stone dust is preferred. The height between the tamped down sand and the stringline must equal the density of the brick or paver.

Now that you have a steady base, place a 1" pipeline or journal board the length of the sidewalk on either side of the walkway. Then using a flatedge, e.g. a 2"x4" board, slide it over the 2 lengths of the pipe/ledger board. In doing this you will create a level area to lay the bricks/pavers.

Now location on the level sand/stone dust strips of plastic brick borders. Install an operate on both sides of the ready area. These strips will serve as your walkway border and assistance to preserve the stability and shape of the walkway. You can get these plastic strip borders at many house improvement stores. The strips must be anchored down with 12" galvinized nails. You should sink these nails into the ground and through the strips every foot.

The key to laying the bricks/pavers is to guarantee that they interlock with each other. Constantly stagger adjacent rows of bricks by 1/2 of a brick to interlock them. This will again assist preserve the stability of the sidewalk.

Undoubtedly bricks/pavers will need to be cut or split when building the sidewalk. To really cut/split the brick/paver, lay it in a bed of sand and place the chisel at a 75 degree angle over the area where you want to break the brick. If your walkway has curves you will require to buy/rent a wetsaw.

After installing the bricks, develop the outside edges with extra sand, and after that shovel in the topsoil and pack down firmly.
Spread stone dust over the new sidewalk and sweep into the cracks. Repeat this procedure a number of times to make sure the fractures are fully filled. This will finish the interlocking of the bricks and assist to get rid of any weed development. Simply add lawn seed to the outdoors edges and you must have a gorgeous entrance to your house within a number of weeks.


In addition, installing a Brick or Paver walkway does not always require a pro. The key to setting up a Brick or Paver Walkway is to very first appropriately prepare the area check here where the bricks/pavers are to be set up. Now that you have a stable base, place a 1" pipeline or journal board the length of the sidewalk on either side of the pathway. These strips will act as your pathway border and aid to maintain the stability and shape of the walkway. Inevitably bricks/pavers will require to be cut or split when developing the sidewalk.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15

Comments on “Installing a Brick Paver Walkway or Engineering Bricks”

Leave a Reply

Gravatar